Braze Perfect ALUMINUM BRAZING WIRE- MSDS Sheet

SUPPLIER / MANUFACTURER

Mobilair 2000
PO Box 32, Station 'U', Toronto, Ontario Canada M8Z 5M4
1-800-538-6057

SECTION 1 - IDENTIFICATION

Trade Name: Braze Perfect
Synonyms: Aluminum brazing wire

SECTION 2 - HAZARDOUS INGREDIENTS

INGREDIENT CAS# OSHA PEL ACGIH TLV
Aluminum 7429-90-5 None Established 10.0 mg/m3
Silicon 7440-21-3 5.0 mg/m3 10.0 mg/m3

All other ingredients are nonhazardous or inert

SECTION 3 - HEALTH HAZARD INFORMATION

EYE CONTACT: Contact with eyes may cause irritation and abrasion. Eye contact with hot material may cause sever burns.
SKIN CONTACT: No effects from skin contact with ambient temperature material have been reported. Skin contact with hot
material may cause severe burns.
INHALATION: Excessive inhalation of fumes, above the OSHA PEL may cause irritation of the mucous membranes and upper respiratory tract or metal fume fever.
CARCINOGEN: No components of this product are reported as carcinogens by OSHA, NTP or IARC.

SECTION 4 - FIRST AIR MEASURES

EYES: Flush eyes with plenty of water for at least 15 minutes, lifting the upper and lower eyelids occasionally. Get medical attention if irritation develops.

SKIN: Wash the skin using soap or a mild detergent and warm water. Get medical attention if irritation develops.

INHALATION: Move the exposed person to fresh air at once. If breathing has stopped, perform artificial respiration. Get medical attention immediately.

INGESTION: If person is conscious, give large quantities of water to drink. Get immediate medical attention.

SECTION 5 - EXPOSURE CONTROL AND PERSONAL PROTECTION

VENTILATION: Keep dust and fume levels below occupational exposure limits. Local exhaust ventilation may be necessary for some operations.

EYES: Wear dust-proof safety goggles. Goggles with welding shields should be used when working with heated materials.

SKIN: Wear suitable protective clothing and gloves. Do not get on skin. Workers should wash before eating or smoking. If the occupational exposures are exceeded, workers should shower and change clothing before leaving work. (see 29 CFR 1910.1025)

INHALATION: Use with adequate ventilation. If fumes are likely to be generated, use certified respirator that will protect against fumes.

OTHER: Eating and smoking should not be permitted in areas where dust or fume are present. Protective clothing and equipment worn at work should remain at work.

SECTION 6 - HANDLING, STORAGE AND DISPOSAL

Wash thoroughly after handling. Avoid dust generation. Store inside a dry area, at room temperatures. Disposal must be in accordance with applicable local, state and federal regulations. Contact your local, state or federal environment agency for specifc rules. Do not dump into sewers, on ground, or into any body of water.

SECTION 7 - FIRE FIGHTING MEASURES

EXTINGUISHING MEDIA: Carbon dioxide, dry chemical, alcohol foam. Do NOT use water.

UNUSUAL FIRE & EXPLOSION

HAZARDS: None identified

FIRE FIGHTING EQUIPMENT: Wear full bunker gear including a positive pressure self contained breathing apparatus.

PRECAUTIONS: No unusual precautions required.

HAZARDOUS DECOMPOSITION: None Identified.

SECTION 8- ACCIDENTAL RELEASE MEASURES

1. Restrict the area to those persons wearing respiratory protection. Do not allow unprotected people into the area until clean up has been completed.

2. Ventilate the area thoroughly.

3. Collect material in a manner that minimizes further dust generation (i.e., use wet or HEPA vacuum methods)

4. Keep out of sewers and waterways

5. Recycle or dispose of as a waste.

SECTION 9 - CHEMICAL AND PHYSICAL PROPERTIES

FLASH POINT: >500°C MELTING POINT: 1080°F
FLAMMABILITY: Inflammable BOILING POINT: Not Determined
AUTOIGNITION: Not Determined
SOLUBILITY IN WATER: Insoluble
pH: Insoluble DENSITY (WATER=1): Not Determined
VAPOR PRESSURE: Not Applicable % VOLATILE BY WEIGHT: 0
VAPOR DENSITY: Not Applicable EVAPORATION RATE: 0
APPEARANCE: Silver/Grey metal wire, no appreciable odor

SECTION 10 - STABILITY AND REACTIVITY

STABILITY: Stable
HAZARDOUS POLYMERIZATION: Will not occur
INCOMPATIBILITY: None known
CONDITIONS TO AVOID: Excessive heat during storage

SECTION 11- REGULATORY INFORMATION

HAZARDOUS MATERIAL IDENTIFICATION SYSTEM

HEALTH HAZARD: 2- Moderate: Moderately toxic
FLAMMABILITY: 0- Minimal Normally inflammable
REACTIVITY: 0- Minimal Normally stable, does not react with water
PROTECTION: B Safety glasses, gloves

TRANSPORTATION INFORMATION:

UN NUMBER: Not Regulated
ADR/RID: Not Regulated
IMO/IMDG: Not Regulated
ICAO/IATA: Not Regulated


THE DATA INCLUDED IN THIS MATERIAL SAFETY DATA SHEET IS RELATED TO THE SPECIFIC MATERIAL DESIGNATED HEREIN AND DOES NOT RELATE TO USE IN COMBINATION WITH ANY OTHER MATERIAL OR IN ANY PROCESS. THE INFORMATION IS FURNISHED FREE OF CHARGE AND IS BASED ON TECHNICAL DATA WE BELIEVE TO BE RELIABLE. THIS INFORMATION IS INTENDED FOR USE BY PERSONS HAVING TECHNICAL SKILL AND AT THEIR OWN RISK AND DISCRETION. SINCE CONDITIONS OF USE ARE OUTSIDE OF OUR CONTROL, WE MAKE NO WARRANTIES, EXPRESSED OR IMPLIED, AND ASSUME NO LIABILITY IN CONNECTION WITH ANY USE OF THIS INFORMATION.